Hello all!
Here is a solution for the Error if u get when u try to Install install Windows XP.
After booting the CD ablue screen appears with the error message :
***STOP: 0x0000007B (0xF78D2524,0xC0000034,0x00000000,0x00000000)
ERROR MSG ONSCREEN
problem has been detected, and windows has been shutdown to prevent damage to your computer.
If this is the first time you have seen this stop error screen, restart your computer.
If this screen appears again, follow these steps:
Check for viruses on your computer.
Remove any newly installedhard drive or hard drive controller.
check your hard drive to make sure it is properly configured, and terminated.
Run CHKDSK /f /r to check for hard drivecorruption , and then restart your computer.
technical information:
*** STOP: 0X0000007B (0XF78D2524,0XC0000034,0X00000000,0X00000000)
Solution 1
1. Start up , press F2 to enter BIOS
2. Expand the "Drives" section
3. Go to "SATA Operation"
4. Change this from "RAID Auto/AHCI" to "RAID Auto/ATA"
Solution forLENOVO LAPTOP
1. Start up , press F2 to enter BIOS
2. Advanced section
3. Go to "SATA Mode Selection"
4. Change this from "AHCI" to "IDE"
Here is a solution for the Error if u get when u try to Install install Windows XP.
After booting the CD a
***STOP: 0x0000007B (0xF78D2524,0xC0000034,0x00000000,0x00000000)
ERROR MSG ON
problem has been detected, and windows has been shutdown to prevent damage to your computer.
If this is the first time you have seen this stop error screen, restart your computer.
If this screen appears again, follow these steps:
Check for viruses on your computer.
Remove any newly installed
check your hard drive to make sure it is properly configured, and terminated.
Run CHKDSK /f /r to check for hard drive
technical information:
*** STOP: 0X0000007B (0XF78D2524,0XC0000034,0X00000000,0X00000000)
Solution 1
1. Start up , press F2 to enter BIOS
2. Expand the "Drives" section
3. Go to "SATA Operation"
4. Change this from "
Solution for
1. Start up , press F2 to enter BIOS
2. Advanced section
3. Go to "SATA Mode Selection"
4. Change this from "AHCI" to "IDE"
0 comments:
Post a Comment